SAP Netweaver Portal

check these settings under the properties section of the iView...

ApplicationParameter:
Enter the name of the parameter in this field as shown in the ABAP program and then enter the value or enter * for all values. For example if you need sales document as the parameter and you want to execute a program for all sales documents in VBAK table use * as the value.

Parameters Forwarded to Transaction:
Enter a * if you want all the parameter values to be executed in the program variant or enter the specific value of the variant to execute. In the below example I used a specific value that I plan to execute in the ABAP program.
Leave OK CODE empty.




















Here is the program which executes process chains in BI based on a program with the parameter P_CHAIN. Most folks who are familiar with ABAP should be able to figure out what I am talking about and I will try not to get into the fine details here…..i am using this parameter and passing them in the iView in the application parameter section.












The end result is shown below: